flanged electric motor

A gear reducer brings the high speed coming from the motor down to the low speed the machine needs and, in doing so, increases the torque on the output shaft by the same ratio. How... More Details

Our aluminium frame three-phase range consists of 36 models: twelve power steps between 0.25 kW and 11 kW, with one motor at 1000, 1500 and 3000 rpm synchronous speed in each step.... More Details

A flange-mounted motor is a three-phase motor without feet, fixed to the machine through the flange face on its front end shield. It does not rest on a base; its weight is carried ... More Details

A hydraulic power unit consists of a tank, a pump, the electric motor that drives the pump and a valve block. The point that causes the most trouble in a unit is often not the moto... More Details

A calibrating machine evens out the thickness of a slab coming from a gang saw or block cutter at every point; a honing and polishing machine then brings that levelled surface to a... More Details

A CNC stone processing machine is a program-controlled machine that uses diamond tools to produce work such as kitchen countertops, sink cut-outs, reliefs, lettering or three-dimen... More Details

A machine that fills bottles with ayran, oil or fruit juice and a machine that fills pouches with flour, sugar or spices may look similar from the outside, but the motors inside th... More Details

Loose cardboard, stretch film, PET bottles, tin cans or textile offcuts take up a lot of space in storage; a baling press turns this material into tied, stackable blocks. This page... More Details

An inline centrifugal duct fan is a centrifugal fan connected directly into a square or round duct run, taking air in from one side and delivering it on the same axis at the other;... More Details

A vane axial fan carries fixed guide vanes inside its cylindrical casing, placed directly behind or in front of the impeller. Air leaves the impeller with a swirl; the stationary v... More Details

A booster set (hydrophore) delivers water to the tap at the required pressure in a building or plant where mains pressure is not enough: one or more pumps, a pressure vessel, a pre... More Details

A circulation pump does not carry water from one place to another; it turns the same water round and round in a closed circuit. In a heating installation from the boiler to the rad... More Details

A hydraulic power unit is a self-contained package placed next to a press or machine tool, combining the oil tank, motor-pump group, valve block, filter and often an oil cooler. Th... More Details

A vacuum pump removes gas from a closed volume and creates a pressure below atmospheric there. Typical examples are drawing air out of bags on packaging machines, holding panels on... More Details

Wood spindle moulders and CNC routers cut grooves, profiles, carvings and shapes in solid wood, MDF, chipboard or plywood with a rotating tool. For the motor needs of the other mac... More Details

A feed recipe is made of dozens of ingredients: alongside tonnes of maize and meal, a few kilograms of vitamin premix, salt, limestone and enzymes must also enter the mix in the ri... More Details

A plansifter is the large square sifter that separates the mixed stock leaving each passage of a flour mill into flour, semolina and bran. Dozens of stacked sieve frames sit inside... More Details

A circular saw machine uses a rotating toothed disc to rip or cross-cut solid wood, planks and boards. For all woodworking machines see the woodworking machine electric motors page... More Details

In free-stall dairy barns, manure in the walking alleys is pushed into a channel or pit by a scraper blade that moves slowly along the floor. The only source of motion in this syst... More Details

Lifting and handling machines raise the load from the ground, hold it in the air, travel it horizontally and set it down at the required point. Overhead travelling cranes, monorail... More Details